The problem I’m executing is making sure simply rolling a dice isn’t sacrificing you chances at winning the game. This random number generator won’t cheat you, roll too much, or not enough. It will display the random number for a dice through LED’s. The during was not pictured.
Generate Concepts
Above is seen the circuit board given and each piece on it is soldered to the board. Soldering is not easy. You have to be very precise with each piece because you could mess up the whole outcome. We were given the board, LED’s resistors, Capacitors , a switch, and a push button. Along with that we got step by step instructions of how to properly install everything.
Construct and Test Prototype
Evaluate the Solution
1. My numbers were quite evenly distributed, but #1 was used a lot. There kept being a reoccurrence with #1. That is why I think it is not fully evenly. Logistically it it isn’t. So in conclusion I don’t think it is that fair because it favors the #1 a lot, and #3 doesn’t get too many. 2. The word debug is from Dr. Grace Hopper, because when she went to trouble shot she found a moth. So she literally debugged her design.
This was my first time soldering and I think I was efficient with the task on hand. I found out I was too bad at soldering and that I actually was quite good at. I like organization to my task so my components were flush to the board. My area was organized at all times and I took my time. I think that’s what made not have to trouble shoot. I took my time making sure all components were in right and always asked if I wasn’t sure about something. One thing that did go wrong was one of my resistors broke, but I was able to replace and finish it perfectly fine. I took it step by step and didn’t skip over directions.